one. Specifies the safety operation requirements for gear processing machines; it applies to the operators of all gear processing machine tools in the Bureau.
two. The use and maintenance of gear processing machine tools must be handled by special personnel and must not be operated without approval.
three. Before driving, check whether the machine parts are running normally and whether the electrical equipment is safe and reliable.
four. When the gear is divided, it is necessary to cut off the power supply, and the bite gap between the gears is appropriate and the protective cover must be covered.
Fives. Start eating knife can not be too big too fast, shake the knife must have data, take out after the shake out, use the automatic knife to set a limit insurance.
six. During the cutting process, the head and hand must not be near the hob. When unloading the workpiece, the workpiece should exit the cutting position. It is forbidden to wipe the rotating tool, workpiece or other rotating parts of the machine by hand or cotton yarn.
Seven. The cutter must be cautiously slow, and the processed steel parts should have sufficient coolant.
Eight. During the machining process, it is necessary to pass the knife one time and try not to stop in the middle (especially hydraulic machine tools).
nine. Install and place the hob, and find the correct disc should pay attention to safe and secure.
two. The use and maintenance of gear processing machine tools must be handled by special personnel and must not be operated without approval.
three. Before driving, check whether the machine parts are running normally and whether the electrical equipment is safe and reliable.
four. When the gear is divided, it is necessary to cut off the power supply, and the bite gap between the gears is appropriate and the protective cover must be covered.
Fives. Start eating knife can not be too big too fast, shake the knife must have data, take out after the shake out, use the automatic knife to set a limit insurance.
six. During the cutting process, the head and hand must not be near the hob. When unloading the workpiece, the workpiece should exit the cutting position. It is forbidden to wipe the rotating tool, workpiece or other rotating parts of the machine by hand or cotton yarn.
Seven. The cutter must be cautiously slow, and the processed steel parts should have sufficient coolant.
Eight. During the machining process, it is necessary to pass the knife one time and try not to stop in the middle (especially hydraulic machine tools).
nine. Install and place the hob, and find the correct disc should pay attention to safe and secure.
Revitalize Skin NMN 18000 Capsules,Reduces Spots NMN 18000 Capsules,Reduces Wrinkles NMN 18000 Capsules
Shanghai Canal International Trade Co.,Ltd , https://www.nmncanal.com