1. Use a drill to make a hole in the gear shaft and lock the connecting rod with a screw.
2. Use a drill to make a hole and use a screw to lock the rail clamp to prevent it from shifting.
3. Turn the railing to the upright position and adjust the position of the balance arm and arm so that their position is as shown in the figure, install the joint bearing, and apply Vaseline to each transmission element.
4. The end face of the arm should be in the same plane as the end face of the connecting rod. 5. Start the switch and allow the gate gate machine to operate to the lift lever position (with the connecting rod turning downwards). During the operation of the Hefei automatic crossing gate manufacturer, press the arrow by hand. The upper stroke limit switch of the indication position (upper limit micro switch), the machine should be able to stop running.
6. During operation, the position of the limit switch indicated by the red arrow is adjusted so that when the machine is up, the connecting rod is close to the upper limit switch position.
1. Each gear must be painted with a proper amount of petroleum jelly.
2. The bolts for the fixed joint bearing must be coated with anaerobic adhesive to prevent loosening of the bolt.
3. Four limit switches must be able to operate normally.
4. The hole of the fixed railing chuck and connecting rod must be drilled to about 2mm to prevent the depth from being insufficient, resulting in the axial displacement of the railing clamp or connecting rod.
5. During the operation of the machine, there must be no abnormal noise.
6. The wiring must be correct to prevent damage to the controller or motor.
2. Use a drill to make a hole and use a screw to lock the rail clamp to prevent it from shifting.
3. Turn the railing to the upright position and adjust the position of the balance arm and arm so that their position is as shown in the figure, install the joint bearing, and apply Vaseline to each transmission element.
4. The end face of the arm should be in the same plane as the end face of the connecting rod. 5. Start the switch and allow the gate gate machine to operate to the lift lever position (with the connecting rod turning downwards). During the operation of the Hefei automatic crossing gate manufacturer, press the arrow by hand. The upper stroke limit switch of the indication position (upper limit micro switch), the machine should be able to stop running.
6. During operation, the position of the limit switch indicated by the red arrow is adjusted so that when the machine is up, the connecting rod is close to the upper limit switch position.
1. Each gear must be painted with a proper amount of petroleum jelly.
2. The bolts for the fixed joint bearing must be coated with anaerobic adhesive to prevent loosening of the bolt.
3. Four limit switches must be able to operate normally.
4. The hole of the fixed railing chuck and connecting rod must be drilled to about 2mm to prevent the depth from being insufficient, resulting in the axial displacement of the railing clamp or connecting rod.
5. During the operation of the machine, there must be no abnormal noise.
6. The wiring must be correct to prevent damage to the controller or motor.
Product categories of Core Filling Snack Machine, the line produce variety shapes snacks, such as ball, tube, stick, ring, star, wheel, etc.
We are specialized manufacturers with 15 years of extruder experience, we have the perfect after-sales service and technical support. Look forward to your cooperation!
Core Filling Snack Machine,Extruded Core Filling Snack Machine,Automatic Core Filling Food Machine,Chocolate Core Filling Snacks Machine
Jinan Chenyang Technology Co., Ltd. , https://www.cyfoodtruck.com