The structure of this magnetic separator is shown in Figure 1. It mainly consists of three main parts: cylinder 1, magnetic system 2 and bottom 3 (slot).
Figure 1 Semi-reverse flow type permanent magnetic cylinder magnetic separator
1-cylinder; 2-magnetic system; 3-groove; 4-magnetic guide plate; 5-bracket; 6-spray pipe; 7-feeding tank;
8-unloading water pipe; 9-bottom plate; 10-magnetic declination adjustment device; 11-bracket
The cylinder is made of a 2 to 3 mm stainless steel plate. Cast aluminum cover member is cylindrical, and is connected to the barrel with stainless steel screws. Stainless steel ( copper ) or aluminum is used as the cylinder because these materials are non-magnetic materials and have good magnetic permeability, so that the magnetic lines of force do not form a magnetic short circuit with the cylinder. The surface of the cylinder is also covered with a layer of wear-resistant rubber to protect the cylinder surface from wear. At the same time, it is beneficial to the magnetic mineral particles to adhere on the cylinder surface, and strengthen the carrying effect of the cylinder on the magnetic ore particles, and the cylinder is driven to rotate by the motor.
The magnetic system 2 of Fig. 1 is a three-pole permanent magnet magnetic system, and also has four or more poles. The polarities of the magnetic poles are alternately arranged in the direction of rotation of the cylinder, and are fixed during operation. When the magnetic ore particles are attracted to the surface of the cylinder and rotate with the cylinder, a magnetic tumbling (also called magnetic stirring) occurs due to the alternating polarity, and a part of the non-magnetic particles which are mechanically mixed in the magnetic ore particles are removed. Come out, you can improve the quality of magnetic products.
Figure 2 shows the magnetic field characteristics of the CYT-600×1800 magnetic separator.
Fig. 2 Magnetic field characteristics of CYT-600×1800 mm semi-countercurrent type permanent magnetic cylinder magnetic separator
As can be seen from Fig. 2, the distribution of the magnetic field strength in the radial direction is saddle-shaped, and the further away from the cylinder surface, the smaller the magnetic field strength. On the surface of the cylinder, the magnetic field strength at the edge of the magnetic pole is higher than the magnetic field strength at the center of the pole face and the center of the pole, 20 mm away from the surface of the cylinder. The magnetic field strengths of the other points are similar except for the two outermost points of the magnetic pole.
Cocoa Butter Press Machine
Our cooking oil pressing machine is widely used in oil making industry. It can press many different raw materials, such as cocoa, peanut, sesame, almond, olive, sunflower seeds etc. The oil rate is much higher than other types of oil press machine.
Our hydraulic cooking oil maker machine has a heating device, the machine can be preheated before pressing, and the oil yield is higher.
Our cold oil press machine uses a compound pump. A compound pump is a combination of two piston pumps, one is a gear pump and the other is a plunger pump. We use the latest gear pumps and plunger pumps, which do not require oil seals at all. Zero cost maintenance.
Cocoa Butter Press Machine,Hydraulic Cold Cocoa Butter Press,Cocoa Butter Extractor,Cocoa Bean Oil Extraction Machine
Henan Gems Machinery Co.,Ltd , https://www.gemsmachines.com